Digital Identification Solutions XID 8300 Manual de usuario Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 35
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
Instruction Manual Page 7
EDIsecure
®
XID 8300 Ethernet Printer Driver
Item
Description
X
Y
W
H
Ink
Side
Start X-coordinate of the printing area by millimeter.
Start Y-coordinate of the printing area by millimeter.
Width of the printing area by millimeter.
Height of the printing area by millimeter.
Ink valid for the printing area.
1. SP-Ink2 : Area to print using the Special ink 2.
2. YMCK : Area not to be printed using all YMCKUV inks.
The side of the card for which the printing area is valid.
1. Front : Front side
2. Back : Back side
Add
Registers the input data. You can enter up to 8 input data.
Delete
Deletes the information selected in the list.
Delete All
Deletes all registered information.
SP-ink2 energy
E1, E2, E3
Print density of the special ink 2.
Do not change the following values.
E1 : 225 , E2 : 160 , E3 : 160
Caution: Each of the set values must satisfy the following
requirements.
Caution: Special ink 2(SP-Ink2) can be used by a printer with PO (peel off) print function. Please
consult our authorized dealers for details.
The following values are recommendation when you print with PO (peel off) function on the magnetic stripe
area of the card.
X
Y
W
H
Ink
0
0
87.46
13.89
1 (SP-Ink2)
0
0
87.46
15.92
2 (YMCK)
Remarks: The input value of the text box may differ from the value of the “Printing area information”
portion by an accidental error in calculation.
Note: The printing starting position that is set with application software may not match with the
above mentioned X=0 and Y=0.
It is not possible to print on the card about 1mm from the edge of the picture. Please refer to
figure in page 33 for details.
Vista de pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Comentarios a estos manuales

Sin comentarios